Difference between revisions of "LoadTileData"
Jump to navigation
Jump to search
(Created page with "= {E8} {{IE_E8}} = {{IE_E8_ex}} Loads the tile data of a specified tile on the currently loaded map. See also: {E9} {{IE_E9}} ― Event_Instructi...") |
m (Xifanie moved page Event Instruction E8 to LoadTileData) |
(No difference)
|
Latest revision as of 05:11, 23 February 2021
Contents
{E8} LoadTileData
LoadTileData(xVR,xBO,+XXX,+YYY,xEL)
Loads the tile data of a specified tile on the currently loaded map.
See also: {E9} SaveTileData ― {C1} LoadAddress ― {C4} SaveAddress
Variable : Byte (hex)
ID of the Variable which will be written to.
Warning: Only x00-x7F (words) are valid with this instruction!
Click here for the list of Variables
Byte Offset : Byte (hex)
Byte holding the data that you'd like to load.
- x00:
- x00-x3F: Surface type (Grass, water, stone, etc.)
- x01: Unknown
- x02: Height (For sloped tiles, the height of the bottom of the slope)
- x03:
- x20-xF0: Depth (Works on any tile; not just water. Warning: This artificially raises tile height)
- x20: 1 Depth
- x40: 2 Depth
- x60: 3 Depth
- x80: 4 Depth
- xA0: 5 Depth
- xC0: 6 Depth
- xF0: 7 Depth
- x00-x10: Slope Height (For sloped tiles, the difference between the height at the top and the height at the bottom)
- x20-xF0: Depth (Works on any tile; not just water. Warning: This artificially raises tile height)
- x04: Slope Type
- x05: Unknown
- x06:
- x80: Units cannot stop on tile (But may still walk on/through it)
- x04-x0C: Shadow Level covering the unit
- x0C: Very Dark
- x08: Dark
- x04: Light
- x00: None
- x02: Selectable Obstacle (Red cursor and units cannot walk on/off tile, but may jump over)
- x01: Unselectable Obstacle (Cannot be selected with the cursor and units cannot walk on/off tile, but may jump over)
- x07: Unknown
X : Byte (unsigned)
X Coordinate of the tile.
Y : Byte (unsigned)
Y Coordinate of the tile.
Elevation : Byte (hex)
- x00 Not Elevated
- x01 Elevated